www.dsk.com.au

Weather getting right for spending plenty of time in the shed Rusty.

Repaired the bottom edge of the wheel tub and got the drivers side front floor welded in.

Great work as usual Rusty!

Repaired the rust on the lower edge of the windscreen/dash edge. Made the repair pieces a little bit higher and that allowed me to carefully linish the edge back...

Front on this weekend mate? Coming along nicely, I’m impressed with your attention to details and patience, great to see how it’s all coming together

Thanks Ian, front is now on and feel like things are moving in the right direction. I also cut and shut the bullet indicator mounts as the KF nose had them pointing in the air a little. Didn't get pics of this though...

Outer valance welded in place....


Trial fit to see how it lines up...


Wiper holes didn't line up from the lower windscreen so these required cutting and moving. Forgot to get picks of this process other then this one...


Lower windscreen lined up and plug welded from the back and headlight buckets welded in...



Made these jigs before pulling the nose off. Got the idea after seeing Ian use Coopers. Used them to help line everything up and get the windscreen gap dialed in...


Welded and grinding...



Edges plug welded and folded around to finish off the sides...



Rolled it over to plug weld the bottom edge from underneath...


Used this door skinning tool to crimp the side and bottom flanges. It did a really neat job...

Where did you get that tool from? I used the old hammer and dolly method and my forearm was on fire. Wouldn’t mind giving it a pass with one of them for insurance.

That's a ton of progress mate, nice work.

so good man...

@animal ...

MID WEST DUBBER wrote: ↑Sun Jun 05, 2022 7:46 pm Made these jigs before pulling the nose off. Got the idea after seeing Ian use Coopers. Used them to help line everything up and get the windscreen gap dialed in...

splitthis wrote: ↑Mon Jun 06, 2022 7:23 am Where did you get that tool from? I used the old hammer and dolly method and my forearm was on fire. Wouldn’t mind giving it a pass with one of them for insurance.

jbtools.com is where I got mine from Matt. Astro pneumatic ds1000 pneumatic door skinning tool

Chers mate.

You’re smashing it Rusty, you’ll be painting in no time.

Solid work Rusty!

MID WEST DUBBER wrote: ↑Mon Jun 06, 2022 9:36 pm

splitthis wrote: ↑Mon Jun 06, 2022 7:23 am Where did you get that tool from? I used the old hammer and dolly method and my forearm was on fire. Wouldn’t mind giving it a pass with one of them for insurance.

jbtools.com is where I got mine from Matt. Astro pneumatic ds1000 pneumatic door skinning tool

Was going to ask same question iv been hunting everywhere for that tool and couldn’t find it

Coming along nice man

Some more work completed on the front wheel tubs. Filling in the gaps and getting ready to fab the lower front seat belt mounts. Will be recreating the factory style mounts..