My 1962 11 Window Split

Post pics and info of your rides here split windows only

Moderators: warb, Rawdyn, Leroy, byronbus, Tonz Magonz, dmb

User avatar
bleiner
DSKer
Posts: 334
Joined: Tue Nov 08, 2011 8:41 pm
Location: Melbourne

My 1962 11 Window Split

Post by bleiner »

Hey guys.

I've had a few requests for photos of my new kombi, so here they are.

I've been on the hunt for around 6 months now and have received a lot of tips and help from DSKers in that time. Very thankful to everyone who's lent a hand.

I bought this 1963 11 window off DSK member Paul Willans last week and it is scheduled to arrive next tuesday.

Sorry that the photos aren't high resolution, but unfortunately I haven't had a chance to take any of my own photos just yet.

At some stage in the future this bus will likely undergo a full re-spray, get safaris all round and a fully re-trimmed interior, however not sure on exactly when all this will happen.

For now, this car will (maybe) be my daily drive. I'll drive her around for a good month before I make the decision to sell my current daily driver.

For those interested, here's a bit of info about the bus:

1. Motor is a Pobjoy steroid 1916 cc (build number 1486). Runs twin Weber 44idf's with 044 heads. Has remote oil cooler and filter fitted.
2. Type 3 gearbox.
3. Front end is a vintage VW narrowed/lowered adjustable beam.
4. Aftermarket short throw shifter.
5. All new brake lines and master cylinder.
6. Brand new porsche fuchs and tyres
7. Samba trim.
8. New rubbers all round.
9. Some VERY minor rust in the cargo door sill and some extremely small pin holes in the front floor which aren't even noticeable. The underside of the chassis is perfect with no rust. No rust in the gutters or any of the usual places.
10. Very straight body with next-to no dents.
11. The paint is a little rough and will appreciate a re-spray at some point in the future.
12. Interior is in very good condition, all carpeted and clean.
13. Has the original middle seat.


Anyway, here's the photos guys, let us know what you think.

Cheers,

Braden
Attachments
Kombi 2.JPG
Kombi 2.JPG (38.12 KiB) Viewed 2780 times
Kombi 3.JPG
Kombi 3.JPG (35.58 KiB) Viewed 2780 times
Kombi 4.JPG
Kombi 4.JPG (34.74 KiB) Viewed 2780 times
Kombi 5.JPG
Kombi 5.JPG (31.14 KiB) Viewed 2780 times
Kombi 7.JPG
Kombi 7.JPG (41.32 KiB) Viewed 2780 times
Kombi 8.JPG
Kombi 8.JPG (28.16 KiB) Viewed 2780 times
photo 3.JPG
photo 3.JPG (60.44 KiB) Viewed 2780 times
photo 2.JPG
photo 2.JPG (58.67 KiB) Viewed 2780 times
photo 1.JPG
photo 1.JPG (47.26 KiB) Viewed 2780 times
photo 4.JPG
photo 4.JPG (50.78 KiB) Viewed 2780 times
Last edited by bleiner on Sat Sep 22, 2012 4:12 pm, edited 1 time in total.
User avatar
KombiMadness
DSKer
Posts: 783
Joined: Fri Aug 12, 2011 8:13 pm
Location: Sunshine Coast

Post by KombiMadness »

Looks good Braden! You must be chuffed... :D

Hey Paul, where was this one hiding when I came to look at your '55?
User avatar
splitbus
DSKer
Posts: 3232
Joined: Sun Dec 09, 2007 7:47 am
Location: Brisbane Northside

Post by splitbus »

Very nice, a good year as well 8)
Mike |o\*/o| 55 11 Window

I don't have a bucket list I have a fu#kit list a mile long
User avatar
MID WEST DUBBER
DSKer
Posts: 1266
Joined: Fri Jan 06, 2012 4:49 pm
Location: Near Horsham, VIC

Post by MID WEST DUBBER »

Very nice! 8) gotta love a good 63.

Rusty.
User avatar
smifff
DSKer
Posts: 395
Joined: Tue Oct 05, 2010 10:06 pm
Location: Woongarrah, Central Coast

Post by smifff »

Very cool. 8) 8) 8)
Dreaming of split kombis.

Daisy our '61 11 window (under construction)
Edna our '74 Camper
User avatar
067DUB
DSKer
Posts: 2884
Joined: Mon Oct 24, 2011 5:09 pm

Post by 067DUB »

Sweet ride dude, ready to roll for winter!! , love the Porsche decal with the fuchs.. works for me :D
User avatar
Kombi Trip
DSKer
Posts: 1493
Joined: Thu Dec 29, 2005 5:20 pm
Location: Far North QLD
Contact:

Post by Kombi Trip »

very nice.
Loose the porsche decal and it will be very very nice. : 8) .
Imagine what you would do if you knew you couldn't fail.
User avatar
bleiner
DSKer
Posts: 334
Joined: Tue Nov 08, 2011 8:41 pm
Location: Melbourne

Post by bleiner »

Thanks guys. Don't worry, Porsche decal will be the first thing to go :)
User avatar
bleiner
DSKer
Posts: 334
Joined: Tue Nov 08, 2011 8:41 pm
Location: Melbourne

Post by bleiner »

Hey guys.

Just an update on the split.

I've had a bit of bad luck with the engine unfortunately. The engine is dead and so am in the process of organising to get it rebuilt.

I'm looking at about $4k - $4.5k to get it back to how it would have been originally.

On top of this, im organising to get discs installed on the front, a new exhaust will be made for the rear and heater boxes will be installed. I'm also replacing some clutch components as some of the parts that were installed weren't compatible with the gearbox.

I look forward to getting this back on the road in the next month or so.

I'll let you know how it all goes.

Braden.
User avatar
bleiner
DSKer
Posts: 334
Joined: Tue Nov 08, 2011 8:41 pm
Location: Melbourne

Post by bleiner »

Also, some other things I have done in the last few weeks:

1. I went to the bumper with a can of gloss white spray paint (as a short term tidy-up). It came up a treat. See below.

2. I have purchased a rear seat which I will be collecting this weekend.

3. I removed the seat cover from the middle seat and the upholstery is in extremely good condition. I will try and upload a photo of it in a couple of weeks when i've got the car back.

4. I replaced the ignition barrel. The one previously installed was just a universal ignition switch so i replaced it with the same one.

5. I replaced the speedo as the one installed had a broken needle and also got the speedo cable working again :-)

6. Got keys cut to suit the door locks.

Can't wait to actually take it for a drive. Still haven't had the chance due to the engine troubles.
User avatar
bleiner
DSKer
Posts: 334
Joined: Tue Nov 08, 2011 8:41 pm
Location: Melbourne

Post by bleiner »

Also, some other things I have done in the last few weeks:

1. I went to the bumper with a can of gloss white spray paint (as a short term tidy-up). It came up a treat. See below.

2. I have purchased a rear seat which I will be collecting this weekend.

3. I removed the seat cover from the middle seat and the upholstery is in extremely good condition. I will try and upload a photo of it in a couple of weeks when i've got the car back.

4. I replaced the ignition barrel. The one previously installed was just a universal ignition switch so i replaced it with the same one.

5. I replaced the speedo as the one installed had a broken needle and also got the speedo cable working again :-)

6. Got keys cut to suit the door locks.

Can't wait to actually take it for a drive. Still haven't had the chance due to the engine troubles.
Attachments
Kombi bumper.JPG
Kombi bumper.JPG (401.47 KiB) Viewed 551 times
User avatar
FrankenCab
DSKer
Posts: 3528
Joined: Wed Apr 18, 2007 8:55 pm

Post by FrankenCab »

what engine dramas ? as motor came out of a race car
User avatar
D-Train
DSKer
Posts: 3492
Joined: Mon Nov 28, 2005 3:03 pm
Location: coffs harbour

Post by D-Train »

Do tell what happened to the engine.
User avatar
bleiner
DSKer
Posts: 334
Joined: Tue Nov 08, 2011 8:41 pm
Location: Melbourne

Post by bleiner »

The engine was running like shit when I first checked out the car and Paul had mentioned that he had never had it running right since he bought it.

Thinking this was just a Carby-tune issue, I dropped it off with Mark Holyoak at "Volkswagens by Imported" in Springvale when I finally got it back to Melbourne.

After a day, Mark called me and said that the engine troubles were caused by much more than a carby-tuning issue, the engine was very low on compression and in very bad condition, needing at least a partial re-build.

Booked it in to get the partial re-build with a quote of around $3k.

Once Mark had spent a day stripping the engine down, he called me and basically said that the engine was F*%&@D and it was a lot worse than he had thought.

I'm going in to see him this morning and work out what has gone so wrong with this engine and how much $$ i'll need to throw at it to get it right. I'll give you guys an update later today letting you know exactly what is soooo F&*%#D with the engine.

Over the phone, Mark suggested it would probably be around $4-4.5k for all the engine work.

It's all a bit unfortunate, and hoping to get it all resolved in the coming weeks. I'll let you know a bit more info later, and see what you guys reckon.

Cheers,

Braden
Post Reply