www.dsk.com.au

rabidkombi wrote:
Kenny hows the clearance with the vintage speed exhaust tailpipe and the ribbed bumper
Heard it has clearance problems on early ribbed bumper buses

I got to admit it does run close. But we are talking millimeters. With a small amount of effort there is room to manipulate the rear bumper and irons to make this work well. This bus is "very forgiving". But even on a princes you would get this done.

Hi Kenny nice bus looks very similar to mine , on your overhead air vent in front of the interior light is your panel ribbed or flat ? Just trying to work out the change over date , thanks

Thanks for the feedback Kenny

rock'n'roll

paul willans wrote:Hi Kenny nice bus looks very similar to mine , on your overhead air vent in front of the interior light is your panel ribbed or flat ? Just trying to work out the change over date , thanks

Hi Paul,

Here's the overhead in the MM. Like your?

Laying down some Boronia Brown on all three Safari's today. We'll add some age to the end result so its all not so obvious........ The factory safari paint has to go.....

better

WAY better

Nice ,yes same smooth with no centre ridges like 59 +, where'd you get you paint formula

Looks good just need a couple of stickers where the latches are

Tinting. Haha. Bit of this and a bit of that. Got some good crew up here. Got it close. But I'm a harsh judge.

Fronts

That looks killer!

That looks better, nice work!

Aden's work is mind blowing, What this guy done in the car/hotrod world